Lionel produced several 35- and 45-watt transformers through the years, including the 1010, 1025, 1015, and 1016. Lionel MPC produced a similar 4045 transformer in the 1970s. They’re small, but cheap when you can find them, and can be useful when you string them together with other transformers. The problem is the markings don’t tell you what you need to know in order to do that.
I found a video titled How to Lubricate with Labelle, and I thought I would elaborate on how to adapt Labelle’s advice to Marx trains. You don’t have to use Labelle oil and grease necessarily, though I do like their products.
Lubrication is a more controversial topic than it needs to be, but what I find is that when I follow the advice I’m about to present, the train runs cooler, more quietly, with more pulling power, and starts at a lower voltage. All of those are good things. With a single reduction motor, I can pull six of the metal 3/16 scale cars at 7-8 volts. An unlubricated motor might not even start at 7 volts.
The CW-80, unlike postwar transformers, only has two accessory posts. To adjust the Lionel CW-80 fixed voltage, the posts are programmable. If you lost your manual, here’s how to do it.
The accessory voltage was set to 12 volts at the factory, which is usually a good setting, but sometimes they get adjusted, or sometimes you need something different. Here’s how to set it to what you want, in five steps.
I don’t come across burned-out light bulbs in Marx trains very often, but it can happen. When you need to replace a missing or dead bulb, you have some options.
Marx, like its competitors, used a standard E10 screw base in all of its trains and accessories that I know of. It’s best to never say never with Marx, but standardizing on E10 was cost-effective so I doubt there’s any variance. The question is what voltage.
The Lionel LW Trainmaster is a 125 watt transformer that Lionel produced from 1955 to 1966. They are reasonably durable and Lionel made them for a long time. That means you can find them easily on the secondary market. They can be expensive if they have their original box and paperwork. But if you just want to run a train and don’t care about the paper, you can get a serviced LW for $50-$60, and an as-is one for under $40. At 125 watts, it’s the most powerful single-handle transformer of the postwar era.
The LW is a quirky transformer so there are some things about if you need to be aware of if you have other Lionel transformers, but as long as you keep those in mind, it’s a fine transformer that will serve you well. The quirks have nothing at all to do with reliability. Lionel just designed its layout a bit differently than many of their other models. In some ways it’s the ideal accessory transformer. We’ll cover that later.
One thing to keep in mind: Unplug the LW when you’re not using it. It doesn’t have its own power switch. I plug my transformers into a power strip and turn all of them on and off with the strip’s on/off switch.
Someone asked me recently about the Lionel CW-80 and how it compares vs older transformers. That’s a fair question, and one that tends to stir up a lot of emotions on train forums. So I’ll try to present the pros and cons in a fair manner.
As I’ve written before, Lionel 1033 transformers are well regarded because they’re reasonably high wattage (90 watts), very readily available, relatively inexpensive and pretty dependable. They really only have one design flaw: the circuit breaker.
The circuit breaker in my 1033 went bad a couple of years ago. I finally got around to replacing it.