If you have a Lionel locomotive with dirty wheels, cleaning them can be a challenge. Here are some tips for making the job of cleaning Lionel wheels easier.
Disassembling a Lionel 1001, 1060, 8902 or 8302 locomotive isn’t too difficult. The biggest problem is knowing where the three screws are that you have to remove.
These particular locomotives weren’t really designed to be repaired, but there’s some basic work you can do on them with household tools. The 8902 and 8302 locomotives can be cheap sources of a motor for other projects.
When I was 19 or 20, I paid a visit to my old grade school to do some computer repair. My fifth-grade teacher dropped in, saw me cleaning up the contacts on a circuit board, and asked why I wasn’t using Everclear. Cleaning electrical contacts with Everclear is, at least, a practice people talk about a lot.
Well, I couldn’t legally buy Everclear yet, for one thing. But let’s talk about why Everclear is good for cleaning electrical contacts but there are other things that can be better.
I’ve gathered a lot of spray painting tips over the years but I’ve never seen more than 10 collected in one place. Spray paint is a tool, and using it is a skill you can learn. With a bit of practice, you can get enviable results and make the object you’re painting look better than new.
Whether you’re painting something for your house or for your hobby, here are more than 20 spray painting tips to help you paint with the best of them–in the order you’re likely to need to use them in your projects.
I had a Marx 999 that didn’t run well when I pulled it out of storage. When pushing it along the track a few times didn’t yield any measurable improvement, I decided I’d better take it apart and give it a thorough cleaning.
In this case, I worked on a Marx 999, but everything I did applies to any other O gauge train Marx made except for the very late 490 locomotives, whose motors don’t seem to have been designed to let you do any more than replace the brushes.
You may have heard to never use steel wool to clean electric train track, especially Lionel, but you may have never heard the reason why.
There is a good reason.
Disassembling a Marx 490 locomotive isn’t too difficult, but it’s very different from other Marx locomotives.
Once you take one apart, though, you’ll see why it was designed how it was. It was Marx’s lowest-cost locomotive, and it could be assembled without tools, so the labor costs were minimal.
For that matter you only need one tool to take it apart, and since there’s so little in it that can break–not even a headlight–you can find anything you would need to service it at the nearest hardware store or auto parts store.
Disassembling a Marx 999 locomotive isn’t too difficult, and it’s easier than the Marx 666, but it helps to have some instructions.
The nice thing about the 999 is that if you can disassemble it, there’s a long, long list of Marx locomotives that disassemble in pretty much the same way: the Commodore Vanderbilt, the Mercury, the tin Canadian Pacific 391, and the tin steamers 592, 593, 594, 833, 897, 898, and 994.
Marx designed its trains so that a father or older brother could service them, so it comes apart with simple household tools, and you can get most of what you’ll need to service it at the nearest hardware store, with the probable exception of the bulb for the headlight.
Disassembling a postwar Marx 666 locomotive, or its plastic counterpart the 1666, isn’t too difficult, but it helps to have some instructions.
Marx designed its trains so that a father or older brother could service them, so it comes apart with simple household tools, and you can get most of what you’ll need to service it at the nearest hardware or auto parts store, with the exception of the bulb for the headlight.