So the PC that stored my resume got kicked (as in the foot of a passer-by hitting it) and died, and the backup that I thought I had... Well, it wasn't where I thought it was.

Time for some amateur home data recovery. Here's how I brought it back.

This machine ran Windows 2000. The first trick to try on any machine running any flavor of Windows is to boot from a DOS boot disk containing FDISK.EXE and issue the command FDISK /MBR. This replaces the master boot record. A corrupt MBR is the most common malady that causes these dreaded error messages, and this is the easiest fix for it.

That didn't work for me.

The second trick is to use MBRWork. Have it back up the first sector, then have it delete the boot record. Then it gives you an option to recover partitions. Run that, then run the option that installs the standard MBR code. I can't tell you how many times this tool has made me look like I can walk on water.

No dice this time either.

Next I tried grabbing the Windows 2000 CD and doing a recovery install. This has brought systems back to life for me too. Not this time. As happens all too often, it couldn't find the Windows 2000, so it couldn't repair it.

The drive seemed to work, yet it couldn't boot or anything. I could have and probably should have put it in another PC to make sure it was readable. But I didn't have a suitable donor handy. Had there been such a system, I would have put the drive in, checked to see if it was readable, and probably would have run CHKDSK against it.

Lacking a suitable donor, instead I located an unused hard drive and put it in the system. I booted off the drive just to make sure it wasn't a hardware problem. It wasn't--an old copy of Windows 98 booted and dutifully spent 20 minutes installing device drivers for the new motherboard hardware. So I powered down, installed both drives, and broke out a copy of Ghost.

Ghost, as I have said before, doesn't exactly copy data--what it does is better described as reinterpreting the data. This allows you to use Ghost to lay down an image on dissimilar hard drives. It also makes Ghost a fabulous data recovery tool. Ghost complained that the NTFS log needed to be flushed. Well, that requires booting into Windows (and I think that's all that's necessary), but I couldn't do that. It offered to try the copy anyway, so I chose that. So it cranked for about 15 minutes. I exited Ghost, powered down, and disconnected the bad drive. I powered back up, and it booted. Fabulous.

Now I can use Ghost to copy the now-good drive back over to the drive that was bad in the first place. I'll do that, but sending out the resume takes much higher priority.